Water damage
Burst pipe water damage
When a pipe bursts, shut off the main water valve first, then turn off power to any wet area. A plumber repairs the pipe; a restoration company extracts the water and dries the walls, floors and ceilings it reached.
First: Close the main water shutoff, then photograph every wet room before moving anything.
- Typical time
- Pipe repair is often same-day; drying 3–5 days after extraction.
- Repair or replace
- Wet drywall and insulation near the break are often cut out; flooring can sometimes be dried.
Do this first
Close the main water shutoff, then photograph every wet room before moving anything.
Call right away if: standing water inside the house; water coming through a ceiling; a slab leak with warm, wet floors.
In Tucson, pipes rarely burst from cold — the problem is age and pressure. Pinhole leaks in older copper, failed PEX fittings, braided supply lines under sinks and toilets, and ice-maker lines behind refrigerators are the usual culprits. The rare hard freeze does split exposed pipes and outdoor spigots.
Pressurized supply water keeps flowing until the valve is closed, so a burst line can put hundreds of gallons into a house in an hour. The water is clean at first, but it travels inside walls and under flooring where it can't dry on its own.
Burst Pipe Water Damage at a glance
- What it is
- When a pipe bursts, shut off the main water valve first, then turn off power to any wet area.
- Service category
- Water damage
Signs you need burst pipe help
- Water spraying or dripping from a pipe, fitting or supply line
- Sudden drop in water pressure
- Water coming through a ceiling or light fixture
- Wet drywall along the bottom of a wall
- Sound of running water with fixtures off
Pick what's happening
Burst pipe or supply line
Do now
- Close the main water shutoff.
- Turn off breakers for rooms where water is near outlets, fixtures or appliances.
- Photograph the source and every wet room before moving anything.
Avoid
- Don't walk through standing water in a room with live power.
- Don't use a household vacuum on water.
Call: As soon as the water is stopped: the first 24–48 hours decide how much can be dried in place.
Full step-by-step guideWater coming through a ceiling
Do now
- Turn off power to light fixtures and fans in that ceiling.
- Put a bucket under the wettest point; a small hole there relieves a bulge in a controlled spot.
- Move furniture and electronics out of the room.
Avoid
- Don't stand under a sagging ceiling.
- Don't switch on wet light fixtures to check them.
Call: When the ceiling bulges, sags or keeps dripping after the source is off.
Full step-by-step guideQuick answers
Burst Pipe Water Damage: the short version
How long burst pipe water damage takes
Pipe repair is often same-day; drying 3–5 days after extraction.
When burst pipe can wait, and when it can't
Emergency — shut the main valve now; a burst line can release hundreds of gallons an hour.
Fix or replace burst pipe?
Wet drywall and insulation near the break are often cut out; flooring can sometimes be dried.
The visit
How burst pipe water damage is done
- 1
Shut off and make safe
Close the main valve and cut power to wet rooms. Take photos before cleanup.
- 2
Repair the pipe
A licensed plumber replaces the failed section so water can be turned back on.
- 3
Extract and open up
Water is extracted; wet baseboards and the bottom of saturated drywall are cut out so wall cavities can dry.
- 4
Dry and verify
Drying equipment runs until moisture readings reach dry standard, then repairs begin.
What moves the price of burst pipe water damage
- How long water ran before shutoff
- How many rooms and floors it reached
- Ceiling damage from a pipe on an upper floor
- Flooring type and whether it can be dried in place
Before you call
Safe first steps: burst pipe
Safe to do yourself
- •Close the main shutoff (usually where the line enters the house, or at the meter box)
- •Open a faucet at the lowest point to drain the lines
- •Move belongings and photograph the damage
Stop and get professional help if
- •Water reached walls, ceilings or under flooring
- •Water is near the electrical panel or outlets
- •A ceiling is bulging with trapped water
Check coverage near you
Use your location or ZIP code to see whether burst pipe water damage is covered where you are, and the nearest service area.
Location is only used to find the service area nearest you. It stays on your device and isn't stored.
Burst Pipe Water Damage: common questions
Who do I call for a burst pipe?
Call a plumber to stop and repair the pipe, and a water damage restoration company to extract the water and dry the structure. If water is near electrical fixtures, switch that circuit off first.
Is burst pipe water damage covered by insurance?
Sudden pipe bursts are usually covered under homeowners policies; slow leaks that went unnoticed often aren't. Document the damage and keep the plumber's description of what failed.
How much water can a burst pipe release?
A fully burst half-inch supply line can release several gallons a minute — hundreds of gallons in an hour. That's why shutting off the main valve comes before anything else.
Service area
Burst Pipe Water Damage in Tucson & Pinal County
- Tucson
- Catalina Foothills
- Oro Valley
- Marana
- Casas Adobes
- Sahuarita
- Green Valley
- Vail
- San Tan Valley
- Maricopa
- Casa Grande
- Apache Junction
- Gold Canyon
- Florence
- Coolidge
- Eloy
- Arizona City
- Burst Pipe Water Damage in Oracle & San Manuel
- Tanque Verde
- Corona de Tucson
- Picture Rocks
- Superior
- San Manuel
- Kearny
- Mesa
- Gilbert
- Chandler
- Scottsdale
- Glendale
- Boise
- Meridian
- Nampa
Related
Services often paired with burst pipe water damage
Water Damage Restoration
Water damage restoration is the process of stopping the water, extracting it, drying the structure to a measured dry standard, and repairing what couldn't be saved.
Learn more
Ceiling Water Damage
Ceiling water damage comes from above: a roof leak, a pipe or fixture on an upper floor, an AC condensate line, or a water heater in the attic.
Learn more
Slab Leak Water Damage
A slab leak is a leak in a water line under or inside a home's concrete slab.
Learn more
Get help with a burst pipe
Emergency — shut the main valve now; a burst line can release hundreds of gallons an hour.